This 1965 carburetor needs help!

I bought my mustang as a running convertible. That doesn’t mean it ran WELL, it just ran. I have the receipts from the engine/carburetor rebuild, and mechanically speaking the car idles fine. Once I got the car home I found that the carburetor was not operating properly. It would start without hesitation, but the choke didn’t want to move.

The previous owner had compensated by setting the choke more than 90 degrees too rich. The problem is that at 30 mph, the car wants to stall out. Certainly not what I would consider a safe driver.

There is also a significant amount of carbon of the choke valve and a ton of rust on the spring coil. Not only that, but the choke piston is completely missing! The vacumn works just fine, but without the choke piston, that doesn’t matter too much!

I decided to completely disassemble the carburetor, clean the engine paint overspray, replace the gaskets, and dip every nut and bolt. The goal is to restore the carburetor to “new” condition. I scoured a mustang junkyard for a replacement piston, but in the end I’ve decided to replace the choke with an electric, rather than manual, choke. This should provide greater reliability, and although not “original”, it will be unseen beneath the air intake, so I’d be very surprised if anyone noticed.

I’ll post photos once I get the carburetor finished, in the meantime I’m planning on stripping and repainting the air intake and valve covers back to a high quality gold finish.